Note: Before using compressor, remove this bolt and nut, slide handle and link assembly into position and replace bolt and nut through frame and pivot hole in handle and link assembly.

1. Rap all retainers sharply with a light hammer to break keepers loose.

2. Adjust tool jaws to fit over retainer.

3. Compress tool with handle. Position on head and adjust screw to put light tension on spring. Release handle. Tighten screw 3 or 4 turns. Try compressing spring, readjust screw to compress springs just enough to remove keepers. The tool is now adjusted for remainder of springs.

4. To re-assemble, reverse procedure. Compress spring. Place keepers on stem and slowly release handle.